Billings Egress Windows logo Billings Egress Windows đź“ž (406) 637-4899

Billings Window Well Price Estimator

People ask us “how much for a window well” when they really mean one of four separate jobs: a new well, a liner, a drain repair, or just a lid. Each has its own price band on our pricing page, and this estimator lets you combine them the way a real visit usually does.

The question that moves the number most is the meltwater one. When a well sits full of water, the steel is rarely the culprit. The stone bed underneath has clogged with our silty clay or never existed, and the rebuild below the well decides whether the replacement lasts a couple of decades or a couple of seasons. We cannot see that from a photo, so we come out and measure it for free.

Four checks you can do in your own yard

  1. Test the steel. Push a screwdriver in at the dirt line. If it stays solid, a liner may work. If it goes through, plan on a new well. Our rusted well page explains the test in more detail.
  2. Measure it. For an egress well, the opening should project at least 36 inches from the foundation and cover at least 9 square feet of floor area.
  3. Check the depth. Measure from the ground surface down to the bottom. More than 44 inches means a fixed ladder.
  4. Look after a melt. If water sits for days once the snow goes, drainage is the job, and our window well flooding page covers why Billings yards do this.

Once you like the range, send it to the form and our techs show up already knowing the scope. If the basement window itself is too small for a bedroom exit, use our egress cost calculator instead, because that is a bigger project.

Ballpark it first

Roughly how much is my window well job?

Tell us what is wrong with the well, how deep it sits, what you want back, and how it behaves when the snow melts. We pull every range from our own pricing page.

Estimated range Typical Billings pricing, before anyone visits

Our pricing page lists new wells at $1,000 to $3,000, liners at $400 to $900, drain fixes at $300 to $1,000, and lids at $150 to $600 apiece. Most Billings calls end up as a mix of two or more, so this tool stacks them.

Carry this range over to the quote form

Treat this as a ballpark only. What is happening below the gravel is the piece we cannot judge from a picture, so our techs measure in person at no charge.

Frequently Asked Questions

My well floods. Why does that answer raise the range?

The repair lives below the well, not in it. Standing water usually means the rock underneath has silted up with clay or was never put in. Our techs dig beneath the well, set washed stone wrapped in fabric, and route the water somewhere, a footing drain if the house has one or a deep dry well if it does not. Skip that step and a brand new well floods just like the old one.

When does a liner make sense instead of a new well?

When the steel is still sound. Poke it with a screwdriver right where it meets the dirt; if it holds and the anchors are snug, a liner in the $400 to $900 range gives you years of service for far less. If the screwdriver punches through or the well is bowing inward, a liner only covers up a wall that is failing, and we will tell you a new well is the honest call.

When is a ladder required?

Once the well goes past 44 inches deep and the room inside is a bedroom. The rule calls for a ladder fixed in place, with rungs no narrower than 12 inches, sticking out at least 3 inches, and no more than 18 inches apart.

Will you dig a window well in the winter here?

Lids, sure. Digging, usually not. Billings builds to a 36-inch frost depth, and the ground at the well's depth stays locked up much of the cold season. Winter is a good time for us to measure and quote, and we typically start excavation in March.

đź“ž Call (406) 637-4899